SUBCHAPTER J-ELECTRICAL ENGINEERING PART 110-GENERAL PROVISIONS the applicable requirements in this subchapter in effect on the date the installation was contracted for and which are maintained in good and serviceable condition to the satisfaction of the Officer in Charge, Marine Inspection, may be continued in use until replacement is ordered by the Officer in Charge, Marine Inspection, or as specified in the regulations. (d) [Reserved] (e) Electrical systems internal to a pressure vessel for human occupancy (PVHO) need not meet the requirements of this subchapter, but must meet the requirements of Subpart B (Commercial Diving Operations) of part 197 of this chapter. [CGD 74-125A, 47 FR 15232, Apr. 8, 1982, as amended by CGD 94-108, 61 FR 28271, June 4, 1996] § 110.01-2 OMB control numbers assigned pursuant to the Paperwork Reduction Act. (a) Purpose. This section collects and displays the control numbers assigned to information collection and recordkeeping requirements in this subchapter by the Office of Management and Budget (OMB) pursuant to the Paperwork Reduction Act of 1980 (44 U.S.C. 3501 et seq.). The Coast Guard intends that this section comply with the requirements of 44 U.S.C. 3507(f) which requires that agencies display a current control number assigned by the Director of the OMB for each approved agency information collection requirement. 그 (b) Alterations and modifications, such as re-engining, re-powering, upgrading of the main propulsion control system, or replacing extensive amounts of cabling, must comply with the regulations in this subchapter. (c) Conversions specified in 46 U.S.C. 2101(14a), such as the addition of a midbody or a change in the service of the vessel, are handled on a case-bycase basis by the Commanding Officer, Marine Safety Center. [CGD 94-108, 61 FR 28271, June 4, 1996, as amended at 62 FR 23906, May 1, 1997] $110.01-4 Right of appeal. Any person directly affected by a decision or action taken under this subchapter, by or on behalf of the Coast Guard, may appeal therefrom in accordance with subpart 1.03 of this chapter. 8. [CGD 88-033, 54 FR 50380, Dec. 6, 1989] bers aper the approval of the Director of the Federal Register under 5 U.S.C. 552(a) and 1 CFR part 51. To enforce any edition other than that specified in paragraph (b) of this section, the Coast Guard must publish notice of change in the FEDERAL REGISTER; and the material must be available to the public. All approved material is available for inspection at the U.S. Coast Guard, (G-MSE), 2100 Second Street SW., Washington, DC 20593-0001, or at the National Archives and Records Administration (NARA). For information on the availability of this material at NARA, call 202-741-6030, or go to: http:// www.archives.gov/federal_register/ code_of_federal___regulations/ ibr locations.html. All material is available from the sources indicated in paragraph (b) of this section. (b) The material approved for incorporation by reference in this subchapter and the sections affected are as follows: American Bureau of Shipping (ABS) American Bureau of Ship ping, ABS Plaza, 16855 Northchase Drive, Houston, TX 77060: Rules for Building and Classing Steel Vessels, 1996 110.15-1; 111.01-9; 111.12–1(a); 111.12-3; 111.12-5; 111.12-7; 111.33-11; 111.35-1; 111.701(a); 111.105-31(n); 111.10539(a); 111.105-40(a); 113.05-7. Rules for Building and Classing Mobile Offshore Drilling 111.12-1(a); 111.12-3; 111.12-5; Units, 1994. American National Standards Institute (ANSI), American National Standards Institute, 11 West 42nd Street, New York, NY 10036: 111.12-7; 111.33-11; 111.35-1; 111.70-1(a). ANSI/ASME A17.1, Safety Code for Elevators and Esca- 111.91-1 ANSI/ASME A17.1A, Addenda to ANSI/ASME A17.1, Safe- 111.91-1. ANSI/IEEE C37.04, Rating Structure for AC High-Voltage 111.54-1(c). ANSI C37.12, For AC High-Voltage Circuit Breakers 111.54-1(c). Guide, 1991. American Society for Testing and Materials (ASTM), 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959: ASTM B 117-97, Standard Practice for Operating Salt 110.15-1. ASTM D 4066-96a, Standard Classification System for 111.60-1. Institute of Electrical and Electronic Engineers (IEEE), IEEE IEEE Std C37.13, IEEE Standard for Low-Voltage AC 111.54-1(c). IEEE Std C37.14, IEEE Standard for Low-Voltage DC 111.54-1(c). IEEE Std 45–1983, IEEE Recommended Practice for Elec- 111.05-7; 111.15-2(b); 111.30-1; tric Installations on Shipboard, 1983. 111.30-5(a); 111.30-19(a); 111.33-5(a); 111.40-1; 111.60-1(a); 111.60-2; 111.60-3; 111.60-5(a); 111.606(a); 111.60-11(c); 111.60-13(a); 111.60-19(b); 111.60-21; 111.6023(d); 111.75-5(b); 111.105-3; 111.105-31(e); 111.105-41; 111.107-1(c); 113–65-5. IEEE Std 100-1992, The New IEEE Standard Dictionary of 110.15-1(a). IEEE Std 320, Application Guide for AC High-Voltage Cir- 111.54-1(c). IEEE Std 331, Application Guide for Low-Voltage AC 111.54-1(c). Separately Mounted Current-Limiting Fuses) (ANSI/ IEEE C37.27), 1987. IEEE Std 1202-1991, IEEE Standard for Flame Testing of 111.60-2; 111.60-6(a); 111.107Cables for Use in Cable Tray in Industrial and Commer cial Occupancies, 1991. International Association of Drilling Contractors (IADC), International Association of Drilling Contractors, PO Box 4287, Houston, TX 77210-4287: 1(c). IADC-DCCS-1/1991, Guidelines for Industrial System DC 111.60-1(f). International Electrotechnical Commission (IEC) 3, rue de IEC 56, High-Voltage Alternating-Current Circuit-Break- 111.54-1. IEC 682-52, Basic Environmental Testing Procedures, 110.15-1(b). IEC 79-0, Electrical Apparatus for Explosive Gas Electrical Apparatus for Explosive Gas Atmospheres, Part 1: Construction and Test of Flameproof Enclosures of Electrical Apparatus, 1990 [Including the First Supplement to the Second Edition (1971), 1975, and Amendment 1 to the Third Edition (1990), 1993]. IEC 79-2, Electrical Apparatus for Explosive Gas Atmospheres, Part 2: Electrical Apparatus-Type of Protection "p", 1983. IEC 79-5, Electrical Apparatus for Explosive Gas IEC 79-7, Electrical Apparatus for Explosive Gas Atmospheres, Part 7: Increased Safety "e", 1990 (Including Amendment 1, 1991, and Amendment 2 1993). 111.105-1; 111.105-3; 111.105–5; 111.105-7; 111.105-15(b); 111.105-17(b). 111.105-3; 111.105-5; 111.105-9; 111.105-15(b); 111.105–17(b). 111.105 111.105–3; 111.105-5; 111.105- 111.105 111.105 111.105 111.105 111.105-3; 111.105-5; وا IEC 79-11, Electrical Apparatus for Explosive Gas 111.105-3; IEC 79-15, Electrical Apparatus for Explosive Gas Atmospheres, Part 15: Electrical Apparatus with Type of Protection "n", 1987. 11(a); 111.105-15(b); 111.10517(b). IEC 79-18, Electrical Apparatus for Explosive Gas 111.105–3; IEC 92-3, Electrical Installation in Ships, Part 3: Cables (construction, testing and installations) Second Edi tion, 1965, as amended through August, 1982. 111.105-5; 111.105 15(a); 111.105-15(b); 111.10517(b). 111.05-7; 111.60–1(a); 111.60-3(a); 111.60-3(c); 111.81–1(d). IEC 92-101, Electrical Installations in Ships, Part 101: 110.15-1(a); 111.81-1(d). Amendment 1, 1995). IEC 92-201, Electrical Installations in Ships, Part 201: 111.70–3(a); 111.81-1(d). IEC 92-202, Electrical Installations in Ships, Part 202: 111.50-3(c); 111.50-3(e); 111.50- IEC 92-301, Electrical Installations in Ships, Part 301: IEC 92-302, Electrical Installations in Ships, Part 302: 3(g); 111.53-1(a); 111.54-1(a); 111.81-1(d). 111.25-5(a); 111.70-1(a); 111.81 1(d). 111.30-1; 111.30-5(a); 111.3019(a); 111.81-1(d). IEC 92-303, Electrical Installations in Ships, Part 303: 111.20-15; 111.81-1(d). 111.33-3(a); 111.33-5(b); 111.811(d). IEC 92-306, Electrical Installations in Ships, Part 306: 111.75-20(a); 111.81-1(d). IEC 92-350, Electrical Installations in Ships, Part 350: 111.60-1. IEC 92-352, Electrical Installations in Ships, Part 352: 111.60-3(a); 111.60-3(c); 111.60-5; 111.81-1(d). IEC 92-353, Electrical Installations in Ships, Part 353: 111.60-1, 111.60-3. with Extruded Solid Insulation for Rated Voltages 1 kV and 3 kV, Second edition, 1995-01. IEC 92-401, Electrical Installations in Ships, Part 401: In- 111.05-9. stallation and Test of Completed Installation, 1987. IEC 92-501, Electrical Installations in Ships, Part 501: 111.81-1(d). Special Features-Electric Propulsion Plant, 1984. IEC 92-502, Electrical Installations in Ships, Part 502: 111.81–1(d); 111.105-31(e). IEC 92-503, Electrical Installations in Ships, Part 503: 111.30-5(a); 111.81-1(d). in the Range Above 1KV up to and including 11KV, 1975. IEC 92-504, Electrical Installations in Ships, Part 504: 111.81-1(d). IEC 331, Fire resisting characteristics of electric cables, 113.30–25(i). IEC 332-1, Tests on Electric Cables Under Fire Condi- 111.30-19(b). IEC 332-3, Tests on Electric Cables Under Fire Condi- 111.60-1(b); 111.60-2; 111.60–6(a); 111.107-1(c). |